Maintenance And Care - Vileda JetClean 0677-01 Mode D'emploi

2
To easily unwrap the cord for use, just turn the quick release cord hook downward to remove the cord from the
cord hook.
Detach handle
see page 5 of this instruction manual.
1
Unscrew only the top centered screw on the back of the product and do not drop the screw.
2
To detach the handle from the body, gently insert the screw driver into the hole where the screw used to be and
lift the handle to release it from the body. Once the handle is released, you can screw the screw back into the
hole so it does not get lost.
Filling your clean water tank
a. The clean water tank is located on the front of the device.
b. Open the blue cap of the clean water tank.
c. Fill with cold water or hand warm tap water (max. 40° C) with help of the water cup to the MAX.
d. Optional: add a drop of non-foaming floor cleaner detergent into the water cup. USE DETERGENT
INSTRUCTION FOR RIGHT DOSAGE; IMPORTANT: DO NOT OVERDOSE THE DETERGENT, IT MAY DAMAGE
THE FLOOR AND THE APPLIANCE
•
Do not overfill the tank, watch out for the MAX level sign!
e. Close the blue cap.
•
Do not fill with hot or boiling water!
Cleaning the nozzle.
see page 4 of this instruction manual.
•
Plug must be removed from the socket-outlet before cleaning or maintaining the appliance. Do not remove
the plug by pulling the cable.
•
It is important to clean JetClean directly after use to ensure a longer life and full functionality of the device.
1
Press nozzle cover button and rotate outwards to remove.
2
Pull microfiber roller out by grabbing the roller tab and pulling upward.
3
Clear out debris and coarse dirt from the suction mouth and channel.
4
Hand rinse the nozzle cover and microfiber roller. For easier cleaning of the microfiber roller, see 'Easy clean
storage tray' instruction. Running your machine with a wet microfiber roller will help the roller dry faster. Wet
mopping and the LEDs in the nozzle should be deactivated.
5
Set your microfiber roller and nozzle cover aside to dry before reassembling.
6
Return the microfiber roller to the main unit by inserting roller end into the left side of the foot, then press the
roller tab back into place.
7 8
Return the nozzle cover by first lining up nozzle cover with edges of the nozzle. Then press the nozzle cover
back into place until you hear a click. Check the side to ensure the proper nozzle cover assembly.
Empty and clean dirt water tank
see page 4 and 5 of this instruction manual.
9
To release dirt water tank from the main unit, pull on red grip of the dirt tank and remove the tank from the unit.
10
Open the dirt water tank by pressing the red opening buttons on the front and back of the dirt water tank and
with your other free hand, carefully remove the dirt water tank cap.
11
Empty dirty water and debris. Rinse clean the inside of the dirty water tank.
12 Remove the filter from the top part of the dirt water tank by pulling it up. Rinse it with water to clear off debris
and coarse particles.
13
Open the mesh grid filter and rinse with warm water through the filter to clear off debris and coarse particles.
14
Hand wash the dirt water tank cap (without filter), removing trapped debris and coarse dirt. In particular clean
the float from all sides, verify the free movement of it. If the inside area where the dirty water tank sits is dirty,
wipe it clean with a cloth or sponge.
15
Leave all parts out to dry before reassembling.

4. MAINTENANCE AND CARE

G
11