Troubleshooting - Vileda JetClean 0677-01 Mode D'emploi

Problem description
Reduced spray OR no spray
Loss of suction power
Water puddle remain on
floor

5. TROUBLESHOOTING

Possible cause
• Clean water tank may be empty
• System isn't wet enough
• Roller nozzle cover is not latched
in place
• Water flow not activated.
• Internal system may be clogged
with dirt.
• Spray tips on nozzle clogged
• Dirt water tank may be not be
inserted properly
• Dirt water tank has picked up
maximum amount of dirty water
and needs to be emptied
• Nozzle cover is not attached in
correct place
• Vacuum channel in nozzle is
clogged by debris
• Air filter clogged by debris
• Floor very uneven with deep tiles
joint
• Nozzle cover damaged (rubber
element eroded)
Possible solution
• Turn OFF and unplug unit. Refill clean
water tank with cold water.
• Activate wet mopping by pressing the
clean water spray swtich on the
handle grip. LED lights will turn on
when water is being distributed. Move
the appliance back and forth to wet
the microfiber roller.
• Turn OFF and unplug unit. Remove
and re-position nozzle cover to firmly
click onto nozzle.
• Activate wet mopping by pressing the
clean water spray swtich on the
handle grip. LED lights will turn on
when water is being distributed.
• Turn OFF and unplug unit. Send unit to
authorized maintenance service.
• Turn OFF unit. Clean the nozzle holes
from dirt with descaling liquid.
• Turn power OFF and remove dirt water
tank. Reposition it properly and press
into the appliance until it clicks.
• Turn power OFF and remove dirt water
tank. Empty dirt water tank
• Turn OFF and unplug appliance.
Remove and re-position nozzle cover
to firmly click onto nozzle.
• Turn OFF and unplug appliance.
Remove and rinse clean the nozzle
cover under tap water.
• Turn OFF and unplug appliance.
Remove the dirt water tank and take
out the 2in1 filter from the tank cap.
Clean the filter following the
instruction of 'Empty and clean dirt
water tank'. If the filter is too dirty,
replace the filter with a new Vileda
2in1 filter.
• Change cleaning direction, go over
the puddles in backwards direction
with water spray off
• Replace the nozzle cover with a new
one
G
13