Vileda JetClean 0677-01 Mode D'emploi page 12

G
Problem description
Microfiber roller is not
turning (LED light in the
nozzle blinking fast)
Device does not turn on
Device dripping from air
exhaust during or after use
Water spillage on floor
during cleaning mode
14
Possible cause
• Blocking has caused microfiber
roller to stop
• Nozzle cover not properly in
place.
• Microfiber roller is not properly in
place.
• Product not properly plugged
into the power socket or issue
with mains power
• Cord is damaged
• Product fell on the floor when
OFF.
• Too much water in the dirt water
tank due to jammed floater.
• Dirt water tank is not emptied
before running the cleaning
mode.
• Too much water filled into the
water chamber at the back of the
easy clean storage tray
• The product is not ON during the
cleaning mode.
Possible solution
• Turn power OFF and unplug unit.
Remove nozzle cover and microfiber
roller to ensure the system is free
from hairs, dirt or larger particles.
• Turn power OFF and unplug unit.
Detach the nozzle cover and
re-position it.
• Turn power OFF and unplug unit.
Remove and reposition the roller
following the instructions for
'Cleaning the nozzle'
• Verify presence of power in the main
power socket. Ensure proper
connection of appliance to the mains
power socket.
• Try in different power socket.
• Turn power OFF and unplug unit
immediately. Send unit to authorized
maintenance service.
• Check product to ensure that it has
not been damaged. 1. Turn power
OFF, follow instruction for 'Empty and
clean dirt water tank'. 2. Turn power
ON and run in its storage tray,
allowing the airflow to dry the air
channels. Note: The product remains
safe even if water is dripping from the
air exhaust during or after use.
• 1. Turn power OFF, follow instruction
for 'Empty and clean dirt water tank'.
2. Turn power ON and run in its
storage tray, allowing the airflow to
dry the air channels. Note: The
product remains safe even if water is
dripping from the air exhaust during
or after use.
• Turn power OFF, follow instruction for
'Empty and clean dirt water tank'.
• Turn power OFF. Use the prescribed
amount of water (150 ml) during
cleaning mode.
• Turn the unit ON during the cleaning
mode to ensure the water is sucked
up into the dirt water tank.