Vileda JetClean 0677-01 Mode D'emploi page 10

G
16
Once parts are dry, reassemble and place the 2in1 filter back into the top of the dirt water tank.
17 Return the reassembled dirt water tank to the main unit, inserting the tank at the bottom first then tilting it and
pressing it with two hands at the top of the tank into the unit until you hear a click.
Note: Replace the 2in1 filter every 4 months or if too dirty
Easy Clean Storage Tray
see page 6 of this instruction manual.
To prevent any harm to delicate floors, always store the appliance in the storage tray. As the appliance works
with water, it could retain water and humidity that can damage delicate floors when not in use.
The storage tray can also be used for a quick clean of the microfiber roller before or after use. For a thorough
cleaning of the device, please refer to MAINTENANCE & CARE on page 11.
•
It is important to clean JetClean directly after use to ensure a longer life and full functionality of the device.
1
Place unit on Easy clean storage tray.
2
Ensure the dirt water tank is empty before running the cleaning mode. If not, empty the dirt water tank,
following the instruction for 'Empty and clean the dirt water tank', before running the cleaning mode.
3
Fill the water cup with 150 ml of water (until the mark), optionally add a drop of non-foaming floor cleaner
detergent. In the case of a high limescale concentration in water, it is recommended to add limescale remover
into the water cup to avoid limescale accumulation in the device.
Caution: The amount of limescale remover should be added accordingly to the limescale remover's
instruction.
4
Unwrap the power cord from the cord hooks, plug into main power socket, and press the power ON button.
5
Pour 150 ml of water into the water chamber at the back of the storage tray while the unit is ON! Allow the
cleaning mode to run 60 seconds untill all water flows through and has been picked up. Repeat if needed.
6
Once all water has been picked up, press the power OFF button. Unplug the unit from the main power socket.
•
Do not remove the plug by pulling the cable.
7
Empty and clean the dirt water tank, following the instruction for 'Empty and clean the dirt water tank'.
8 9
Open the nozzle cover and leave open to dry. From time to time, clean the storage tray under tap water and
let it dry completely before using again.
Note: Pour water in the easy clean storage tray only when the appliance is ON! If the appliance is not running,
the water will spill on the floor. If too much water is poared into the easy cleaning storage tray, this will spill onto
the floor. Do not leave the appliance unattended while the cleaning process in running.
Storage: Store the unit in a protected, dry area. Since the product uses water, it must not be stored where
there is a danger of freezing. Freezing will damage internal components and will void the warranty.
12