Maintenance; Cleaning Dust Bin And Filters - Vileda VR 302 Manuel De L'utilisateur

• Press "POWER" button to enter the minute-setting, the right two numbers on LED panel will flash, press
"MAX" or "HOME" to increase or decrease minutes.
• Press "POWER" button to confirm and save the setting.
• At last, press "PLAN" button to quit the time setting mode.
Note: If machine is in real time setting, pls press "POWER" button to quit the real time setting, then long press
"PLAN" button to enter scheduling setting.
3. Cancel scheduling
• Set the scheduling time to 00:00 in scheduling setting.
!
TIPS FOR EASY SCHEDULING
• The scheduling time uses the machine's time as a reference so before scheduling, please set the robot's
time clock to be the same as real time.
• Once scheduled the machine will start cleaning at the time automatically when the main switch is
switched on. The programed time will remain saved even when switching the device off.
TIPS FOR BEST PERFORMANCE
To keep your Vileda robot at the best level of performance, it is recommended to maintain the robot regularly.
Robot Part
Dust Bin
High efficiency filter and Mesh
Filter
Side Brush and Main brush
Front Wheel and Driving Wheels
Cliff Sensors
Charging Contacts

4.1 Cleaning dust bin and filters

Empty and clean dust bin after each use following the steps as shown in the below figures.

4. Maintenance

Care Frequency
After every uses
Once per week (twice per week in
home with pets)
Once per week (twice per week in
home with pets)
Once per month
Press PUSH to open the cover.
Take out the dust bin
Replacement Frequency
-
High efficiency filter: Every 3
months / Mesh Filter: Every 6
months
Every 6-12 months
-
G
13