Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 94
THE ROBOT IS EQUIPPED WITH THREE DIFFERENT MOVEMENT PATTERNS:
G
Automatic
Spiral cleaning mode
Zig-zag mode
!
TIP FOR ADAPTING THE CLEANING PATTERN
Press "mode" button on the remote control to select the cleaning pattern.
The chosen mode will be displayed on the LED display of the robot:
Mode no. 1111 shows on robot led display: intensive spiral cleaning mode;
Mode no. 2222 shows on robot led display: automatic cleaning mode;
Mode no. 3333 shows on robot led display: fast spiral cleaning mode;
Mode no. 4444 shows on robot led display: zig-zag cleaning mode.
Schedule the robot to start cleaning automatically at a certain time every day.
NOTE: The robot can only be set when it's in standby or charging on docking station. If the robot is in sleep mode,
long press "POWER" button on main body or ON/OFF on remote controller to wake it up. If the robot is in cleaning
mode, pause it before scheduling.
SCHEDULING ON THE ROBOT DISPLAY
1. Time Clock Setting
Press "PLAN" button shortly to enter time setting mode. The LED panel will show the current time. The left
two numbers on LED panel will flash, press "MAX" or "HOME" to increase or decrease hours.
Press "POWER" button to enter the minute-setting, the right two numbers on LED panel will flash, press
"MAX" or "HOME" to increase or decrease minutes.
Press "POWER" button to confirm and save the setting.
Press "PLAN" button to quit the time setting mode.
2. Setting scheduling time (keep the robot in standby or charging on station)
Press "PLAN" button long to enter scheduling setting, the left two numbers on LED panel will flash, press
"MAX" or "HOME" to increase or decrease hours.
12
1.
In this mode, the robot will clean the area automatically
and adjust its cleaning behavior based on specific
situations.
2. In this mode, robot takes the starting point as the center,
then turns outward in a spiral action, suitable for an open
area.
3. The robot will automatically go into Zig-Zag cleaning when it
detects an open area or an environment with less
obstacles.

3.4 Scheduling

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières