Environmental And Product Recycling - Vileda VR 102 Guide D'utilisation Et D'entretien

Problem
Power button flashing quickly red
Power button is 4x flashing red
If above described solutions do not work, please try switching off and on and check again.
For further help, technical advice, or to order spare or replacement parts contact Vileda (address see
last page).

6. ENVIRONMENTAL AND PRODUCT RECYCLING

The Vileda vacuum cleaning robot VR 102 fulfils the EU directive 2012/19/EC, covering electrical and electronic
appliances and the management of its disposal.
The packaging material is entirely recyclable, and marked with the recycling symbol. Follow local regulations for
scrapping. Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of children's reach, as they are
potentially dangerous.
When the product has reached the end of its life please do not dispose of it with general household waste. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly
to promote the sustainable reuse of material resources.
The symbol identifies the Vileda VR 102 as a product submitted to the regime of selective electrical appliance
recycling collection.
The product contains a Li-Ion battery which should not be disposed of with general household waste. Deposit the
battery in an official collection point for its recycling.
Batteries can be detrimental for the environment and can explode if they are exposed to high temperatures. The
violation of these precautions could cause fire and / or serious injuries.
For more detailed information about treatment, recovery and recycling of this robot, please contact your local city
office, your household waste disposal service or the shop where you purchased the product.
For example, disposal of the robot and any part of it may need to be taken to a designated collection facility.
Possible Reason
• Overloaded or jammed motor
• Device is off the ground or
sensors jammed or dirty.
• Dust box not placed in position
or robot without dust box
• Suction passage blocked
• Connection of battery is
notgood
Possible Solution
• Check if fan opening is free
and clean dust box. Check if
wheels or brush unit is stuck or
obstructed with debris
• Put robot on solid ground.
Check sensitivity of the front
bumper and clean sensors
• Put back dustbin and place it
in position
• Clean suction passage with
the maintenance brush
• Contact the Vileda service
(address see last page)
G
13