Environmental And Product Recycling; Battery Removal - Vileda VR301 Manuel De L'utilisateur

Problem
Robot cannot find the Charging
Station.
Robot does not start scheduled
cleaning.
Low Battery after charging for 12
hours
For further help, technical advice, or to order spare or replacement parts contact Vileda (address see
last page)

Environmental and Product Recycling

The Vileda VR301 fulfils the EU directive 2002/96/CE, covering Electrical and electronic appliances and the man-
agement of its disposal.
The packaging material is entirely recyclable, and marked with the recycling symbol. Follow local regulations for
scrapping. Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of children's reach, as they are
potentially dangerous.
When the product has reached the end of its life please do not dispose of it with general household waste. To pre-
vent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly
to promote the sustainable reuse of material resources.
The symbol identifies the Vileda VR301 as a product submitted to the regime of selective electrical appliance
recycling collection.
The product contains a NiMH battery which should not be disposed of with general household waste. Deposit
the battery in an official collection point for its recycling.
Batteries can be detrimental for the environment and can explode if they are exposed to high temperatures.
The violation of these precautions could cause fire and / or serious injuries.
For more detailed information about treatment, recovery and recycling of this product, please contact your local
city office, your household waste disposal service or the shop where you purchased the product.
For example, disposal of the Product and any part of the Product may need to be taken to a Designated Collection
Facility
1. Turn off the power switch and put the robot on a flat surface with its bottom up.
2. Use a cross-head screwdriver to loosen the two screws and remove the battery cover plate.
3. Lift the battery and disconnect the battery by pressing and pulling the flaps at the electrical connector.
Possible reason
• Charging Station is not properly
connected to the mains.
• Charging station is covered by
any obstacle.
• Obstacle sensors of robot or
docking sensor of Charging
Station are dirty.
• Charging Station is not
synchronized.
• Battery of robot is totally empty.
• Remove the battery carefully and
insert it again.
• Robot is turned off.
• Robot is not physically
connected to the power station.
• Weekday for autonomous
cleaning is not selected.
• Charger or battery is defective.

Battery Removal

Possible solution
• Plug the charger correctly to
the mains and to the Charging
Station and check if power
indicator lights up.
• Ensure there is no obstacle
within 3m in front of the
charging station and within
0.5m from its side.
• Clean the sensors with a dry
cloth.
• Synchronize Charging Station
(see section "Battery Charging
& Recharging").
• Charge the robot once
manually.
• Turn the robot on by pressing
the power switch.
• Connect the robot to the power
station (see section "Battery
Charging & Recharging").
• Select weekday for autono-
mous cleaning (see section
"Using the Product").
• Contact Vileda Service (see
last page).
G
13