Battery Charging & Recharging - Vileda VR301 Manuel De L'utilisateur

G
WARNING:
If the battery is damaged in any way, do not attempt to recharge
it. Contact Vileda customer service address (see last page).
Charge the battery manually for 12 hours before first use. After
the first use, charging time is about 4-5 hours
Turn the robot's power switch to OFF when transporting or
when in storage, otherwise the battery may become damaged.
MANUAL CHARGING:
1. Connect the DC plug of the battery charger to the battery charger socket located beside the power switch.
2. Connect the AC plug of the battery charger to the mains. The buttons on top of the robot will flash while charg-
ing and stop flashing when battery is fully charged .
3. Once the battery is fully charged unplug the battery charger from mains and battery charger socket.
SYNCHRONISATION OF CHARGING STATION:
1. Before first use the Charging Station has to be synchronized with the robot.
2. Ensure that the robot is switched off and that the Charging Station is connected to the mains.
3. Press and hold the sync button of the Charging Station with an auxiliary tool (e.g. pencil) while switching the Ro-
bot on by pressing the power switch.
4. If the robot beeps two times the synchronisation was successful, otherwise please repeat the steps mentioned
above.
AUTONOMOUS CHARGING:
1. Install the Charging Station on a hard and flat ground and against a vertical wall.
2. Ensure that there are no obstacles within an area of 3m in front of the Charging Station and within 0.5m on its
right and left side.
3. Connect the DC plug of the battery charger to the battery charger socket of the Charging Station.
4. Connect the AC plug of the battery charger to the mains. The power indicator of the Charging Station will light
up in a red colour.
5. Ensure that the power cord is running alongside the wall, otherwise the robot could get entangled.
6. Ensure that the sensor windows of robot and Charging Station are not covered, otherwise the robot cannot
search for the Charging Station.
7. Place the robot a suitable distance from the Charging Station and switch the robot on, by pressing the pow-
er switch.
8. Press the "OK" button and "up" button on the Timer in succession to make the robot search for the Charging
Station.
0.5m
8
Battery Charging & Recharging
0.5m
3m