Fitting Wheel Guard; Assembly Of The Device - Bosch WBE 4230 Notice Originale

4.3

Fitting wheel guard

1. Use the five bolts supplied to attach the wheel guard
support to the WBE 4230 .
2. Use the four bolts supplied to fit the bottom part of
the wheel guard to the support.
3. Use a pin and bolt to attach the top part of the
wheel guard to the WBE 4230 by way of the support
arm as shown.
Robert Bosch GmbH
Commissioning | WBE 4230 | 35
4.4

Assembly of the device

i
This must be done when the wheel protection cover
is already mounted on the machine.
1. Attach the clamp of the angular width gauge on the
supporting tube of the wheel protection cover by
fastening the three screws in the respective holes.
Fig. 2: Assembly of angular width gauge
2. Connect the angular width gauge connection cable
onto the rear of the balancing machine and fix it
using the straps included, as shown in the picture.
Fig. 3: Connecting the angular width gauge
1 The connecting cable of the angular width gauge
2 Strap
en
|
1 695 656 347 2011-03-18