Operation Controls Front Panel; Operation Controls Rear Panel - Enraf Nonius Endolaser 422 Mode D'emploi

5.2

Operation controls front panel

The front panel of the unit, which comprises the controls and signals, can be seen in fig. 1 with
corresponding key.
[1] Selection button 1
[2] Selection button 2
[3] Selection button 3
[4] Selection button 4
[5] Start – Pause button
[6] Stop button
[7] Laser tester
[8] Output connector for channel 1
[9] Output connector for channel 2
[10] Confirmation button
[11] Central controller
In order to navigate the software you need to use:
•
the central knob, which can rotate both clockwise and anticlockwise, and allows you to move the
selection to the desired option;
•
the buttons on the side of the display (from 1 to 6) that allow you to confirm an option, start or
stop a treatment.
CAUTION:
Use of controls or adjustments or performance of procedures other than those specified herein may result
in hazardous radiation exposure.
5.3

Operation controls rear panel

The rear panel contains the power entry module which consists of the main switch, the fuse box and the
socket for the cord set.
[12] Connection power cord
[13] On / off switch
[14] Fuse box
[15] Interlock connector
EN
7