Installation Instructions; Important - GE Côte à côte 20 Manuel D'utilisation

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737)
Questions? In Canada, call 1.800.361.3400
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
15 minutes
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
WATER SUPPLY TO THE ICEMAKER
)
(on some models
If the refrigerator has an icemaker, it will have to
be connected to a cold water line. A GE water supply
kit (containing tubing, shutoff valve, fittings and
instructions) is available at extra cost from your dealer,
by visiting our Website at ge.com (in Canada, at
www.geappliances.ca) or from Parts and Accessories,
800.626.2002.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run often
enough to maintain proper temperatures.
• Install it on a floor strong enough to support it fully
loaded.
or
Save these
Observe all
Be sure to leave these
Keep these instructions
ge.com
or
Visit our Website at:
www.geappliances.ca
Visit our Website at:
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
• Sides 1/8" (4 mm)
• Top 1" (25 mm)
• Back 1" (25 mm)
A door clearance of 3/4" (19 mm) is needed for a 90º
door opening which provides better access to the food
storage area.
ROLLERS
The rollers have 3 purposes:
s
Rollers adjust so the door closes easily when opened
about halfway.
s
Rollers adjust so the refrigerator is firmly positioned
on the floor and does not wobble.
s
Rollers allow you to move the refrigerator away from
the wall for cleaning.
To adjust the rollers, remove the base grille by pulling it
out at the bottom.
Turn the roller adjusting screws clockwise to raise the
refrigerator, counterclockwise to lower it. Use an
adjustable wrench (3/8" hex head bolt) or pliers.
To replace base grille, line up the clips on back of grille
between the bar and the bottom of the cabinet. Push
forward until grille snaps into place.
14
Refrigerator
Models 20, 22, 25