Abicor Binzel MT 452 W Mode D'emploi page 31

MT/AUT/AUT RAB
6.2.1 Guide spiral liner
1
11
10
9
1 Tip adaptor
2 Torch neck
3 Wire feed hose
4 Central plug
Fig. 3 Mounting the guide spiral liners
To be used for steel wires.
2
8
5 Multiple wrench
6 Spigot nut
7 Holder nipple
8 Guide spiral liner
1 Lay down the hose assembly (9) straight.
2 Unscrew gas nozzle (10) and contact tip (11) from torch neck (2).
3 Unscrew spigot nut (6) from central plug (4).
4 Slide wire guide (8) through the wire feed hose (3) up to the holder
nipple (7).
5 Screw down spigot nut (6) by hand.
6 Cut off the excess length of the guide spiral liner (8) flush with the
torch neck (2) or the tip adaptor (1).
7 Unscrew spigot nut (6) and pull out guide spiral liner (8).
8 Sharpen the spiral guide liner beginning to an angle of approx. 40° and
debur the edge.
9 Slide sharpened guide spiral liner (8) through the wire feed hose (3) up to
the holder nipple (7).
10Screw down union nut (6) and tighten with multiple wrench (5).
11 Screw in contact tip (11) and attach gas nozzle (10).
6 Putting into operation
7
9 Hose assembly
10 Gas nozzle
11 Contact tip
3
4
5
6
EN - 11