Unpacking And Setting Up The Centrifuge; Delivery Checklist - Hettich ROTIXA 500 RS Mode D'emploi

7

Unpacking and setting up the centrifuge

a
b

Remove the packaging.

Remove the front wooden beam (a).

Fasten the metal rails (b) to the wooden pallet with two nails each.

Push the front wooden beam (a) under the metal rails (b) to support these.

Place the open-end wrench included in delivery (size 10 mm) on the surfaces (d) and turn the feet of the device
(c) upward.

Roll the centrifuge carefully down from the wooden pallet using the metal rails (b).

Push the centrifuge to its set-up location.

Place the open-end wrench included in delivery (size 10 mm) on the surfaces (d) and turn the device feet (c)
downward until the castor wheels (f) no longer have contact with the floor.

Align the centrifuge horizontally by turning the device feet (c).

Turn the hexagon nuts (e) upward with the open-end wrench included in delivery (size 19 mm) and tighten to
secure the position of the device feet (c).
8

Delivery checklist

1 Power cord
1 Single open-end wrench, size 10 mm (for turning the device feet)
1 Double open-end wrench, size 17/19 mm (for tightening the hexagon nuts on the device feet)
1 Square wrench (for installing and removing the rotor)
1 Allen key (to unlock the lid in an emergency)
1 Lubricating grease for trunnions
1 Tube emptier
10 Cover caps (12 mm) for Torx screw heads, size T20
1 Operating manual
3 Program-data sheets
The rotor(s) and associated accessories are included in the delivery in the quantity ordered.
f
c
EN
e
d
c
45/138