Electrical Power Supply; Gas Supply; Warnings; Introduction - Thermador Professional P24GE Instructions D'installation

PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING
IMPORTANT: LOCAL CODES VARY. INSTALLATION, ELECTRICAL CONNECTIONS,
GAS CONNECTIONS, AND GROUNDING MUST COMPLY WITH ALL APPLICABLE CODES.
IMPORTANT: Save these instructions for the Local Electrical Inspector's use.
INSTALLER: Please leave these Installation Instructions with this unit for the owner.
OWNER: Please retain these instructions for future reference.

ELECTRICAL POWER SUPPLY:

24" Models
with Wok - 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit
with Griddle - 240 VAC, 60 Hz., 1 Ph., 30 Amp circuit
30'' Models:
4 Burners - 120 VAC, 60 Hz., Ph., 10 Amp circuit
36" Models:
6 Burners - 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit
with Grill - 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit
with 12" Electric Griddle - 120 VAC, 60 Hz., 1 Ph., 15 Amp circuit
48" Models:
6 Burners with Grill - 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit
6 Burners with 12" Electric Griddle - 120 VAC, 60 Hz., 1 Ph., 15 Amp circuit
4 Burners with 12" Electric Griddle and Grill - 120 VAC, 60 Hz., 1 Ph., 15 Amp circuit
4 Burners with Wok - 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit
4 Burners with 24" Electric Griddle - 240 VAC, 60 Hz., 1 Ph., 30 Amp circuit

GAS SUPPLY:

Natural Gas – 6" min. to 14" max. water column.
(14.9 to 34.9 mb)
Propane Gas – 11"min. to 14"max. water column.
(27.4 mb to 34.9 mb)
All sealed burners are rated at 15,000 BTU/HR
(*13,000 BTU/HR on LP), *All models, except 24"
Griddle, are convertible to LP/Propane gas using
an accessory conversion kit.
IMPORTANT
• A backguard must be utilized when there is
less than a 12" horizontal clearance between
combustible materials and the back edge
of the cooktop. The Thermador Low Back
backguard must be ordered separately and
installed at the rear of the cooktop. For island
installations and other installations with more
than 12" clearance, an optional stainless steel
Island Trim is available to cover the backguard
mounting flanges.
Disconnect power before installing.
Before turning power ON, be sure that
all controls are in the OFF position.

Introduction

• Verify that the appliance is correct for the type
of gas being provided. Refer to Step 4 before
proceeding with the installation.
1
WARNING