Connect Electrical Supply; Check The Installation - Thermador Masterpiece Serie Installation

Connect Electrical Supply

CAUTION
9
Before installing, turn off power supply at the service
panel. Lock service panel to prevent power from
being turned on accidentally.
CAUTION
9
To reduce the risk of electric shock and fire, do not
use a flexible power supply cord.
Refer to rating label for more information. See "Customer
Service" for rating label location.
The maximum current rating of the branch-circuit
breaker, the wire sizes and the connections must
conform to the requirements of the National Electrical
Code or Canadian Electrical Code and all local codes
and ordinances.
Attach flexible conduit to the junction box. Connect the
lead wires to the junction box supply wires in proper
phase:
black (L1) to black
▯
red (L2) to red
▯
green or bare to ground
▯
1 House power supply cord
2 Black wire
3 Junction box
4 Cooktop power supply cord
5 Grounded green or bare cable
6 Certified UL connector
7 Red wire
If the cooktop is installed and connected as specified
above, it will be grounded in compliance with the
National Electrical Code.

Check the Installation

CAUTION
9
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the OFF
position.
Remove everything from the cooktop surface including
stickers. Clean cooktop surface with cooktop cleaning
cream.
Switch on the circuit breaker.
Verify that elements function properly.
9