Troubleshooting Guide - General - Bosch CM8S Mode D'emploi

BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 43
pROBlEM
Head assembly does not bevel
to desired position.
Blade hits table.
Angle of cut not accurate.
Cannot rotate table to change miter
angle.
Head assembly will not fully raise
or blade guard will not fully close.
Blade binds, jams, burns wood.
Rough cuts.
Head assembly slides forward and
back when making a chop cut.
Troubleshooting

Troubleshooting Guide - General

Bevel lock is engaged.
Misalignment.
Angle stops at 0° or 45° need
adjustment.
1. Miter lock knob is tightened.
2. Miter detent lever is engaged with
a detent (slot) in detent plate.
3. Sawdust accumulation.
1. Head assembly lock pin is
engaged.
2. Sawdust accumulation.
3. Sawdust accumulation.
1. Improper operation.
2. Dull blade.
3. Improper blade.
4. Bent blade.
Slide rail lock knob is disengaged.
CAUSE
- Pull the bevel lock forward to unlock
the head assembly.
- Authorized service.
- See Adjustments section
(pages 17-20).
- Turn miter lock knob
counterclockwise to loosen.
- Pull up on miter detent lever to
disengage from detent slot (see
page 28).
- Vacuum or blow out dust around
turntable; wear eye protection.
- Pull out lock pin, allowing head
assembly to go up (see page 15).
- Clean head assembly.
- Authorized service.
- See Saw Operations
section.
- Replace or sharpen blade.
- Replace with 8
designed for material being cut.
- Replace blade.
- Rotate Slide rail lock knob
clockwise to lock head in place.
43.
CORRECTIVE ACTION
⁄ " diameter blade
1
2