Bosch CM8S Mode D'emploi page 26

BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 26
WARNING
blade, extend the sliding fence and sliding base
extensions when making extreme bevel, miter or
compound cuts, figure 31.
Operating Sliding fence
1. Loosen the fence lock knob counter clockwise ½
turn to loosen fence (see figure 32).
2. Slide fence to the desired position.
3. Tighten the lock knob clockwise to lock fence
position.
Removing Sliding fences
The sliding fence may need to be removed when
preforming extreme bevel cuts and most compound
cuts.
1. Loosen the fence lock knob counter clockwise 4
rotations, see figure 32.
2. Lift and remove fence.
preparing for Saw Operations
Workpiece Support
Sliding fence
To provide sufficient (minimum
6") spacing from hand to saw
Sliding
fence
fence lock
Knob
26.
FIG. 31
FIG. 32
Sliding
fence