Transport And Intermediate Storage - Wilo HiSewlift 3 Notice De Montage Et De Mise En Service

English
• Leakages (e.g. from the shaft seals) of hazardous fluids (which are explosive, toxic
or hot) must be led away so that no danger to persons or to the environment
arises. National statutory provisions are to be complied with.
• Danger from electrical current must be eliminated. Local directives or general
directives [e.g. IEC, VDE etc.] and instructions from local energy supply companies
must be adhered to.
2.6 Safety instructions for installation and maintenance work
The operator must ensure that all maintenance and installation work is carried out
by authorised and qualified personnel, who are sufficiently informed from their
own detailed study of the installation and operating instructions. Work on the
product/unit must only be carried out when at a standstill. It is mandatory that
the procedure described in the installation and operating instructions for shutting
down the product/unit be complied with.
Immediately on conclusion of the work, all safety and protective devices must be
put back in position and/or recommissioned.
2.7 Unauthorised modification and manufacture of spare parts
Unauthorised modification and manufacture of spare parts will impair the safety
of the product/personnel and will make void the manufacturer's declarations
regarding safety. Modifications to the product are only permissible after
consultation with the manufacturer.
Original spare parts and accessories authorised by the manufacturer ensure safety.
The use of other parts will absolve us of liability for consequential events.
2.8 Improper use
The operating safety of the supplied product is only guaranteed for conventional
use in accordance with Section 4 of the operating instructions. The limit values
must on no account fall under or exceed those values specified in the catalogue/
data sheet.

3 Transport and intermediate storage

When you receive the equipment, check that it has not been damaged during
transport. If you notice a fault, take all necessary action with the carrier within the
time allowed.
• Unpack the lifting unit and recycle or dispose of the packaging in an environmen-
tally responsible manner.
• Be sure to check the condition of the product upon delivery.
CAUTION! Storage environment may cause damage!
If the equipment is to be installed at a later date, store it in a dry place and protect
it from impacts and any external stresses (humidity, frost etc.).
Temperature range for transport and storage: -30°C to +60°C.
Handle the system with care so as not to damage the product before installation.
24
09/2014