Cleaning And Care; Storage - SilverCrest KM 250 D1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
NOTE
Do not prepare large quantities all at once,
but in several portions. Empty the bowl 5
after each use.
Do not allow the appliance to operate for
long periods when chopping (hard) cheese or
chocolate. Otherwise the ingredients will
become too hot, start to melt and clump.
Never allow the appliance to run for longer
than 1 minute! Otherwise, the motor unit could
overheat!

Cleaning and care

DANGER! RISK OF ELECTRIC SHOCK
Always remove the plug from the mains power
socket before cleaning the appliance.
Under no circumstances must the motor
unit 7 be submerged in liquid! This could
result in a potentially fatal electric shock
and the appliance could be damaged.
Never open the appliance housing! Otherwise
there is a risk of a fatal electric shock.
WARNING RISK OF INJURY!
Take extreme care when cleaning the cutting
blades 4, the slicer attachment w and the
grater attachment q. These parts are
extremely sharp!
CAUTION! PROPERTY DAMAGE!
Do not use solvents or abrasive cleaners. These
will damage the surface of the appliance!
Do not use abrasive, aggressive or chemical
cleaning agents! They could irreparably
damage the surface!
8 
GB │ IE
NOTE
Always clean all parts immediately after use.
This makes food residue easier to remove.
Processing strongly staining foods, such as
carrots, can lead to staining of the plastic
parts on the appliance. This is not a defect in
the appliance and will not adversely affect
operation.
You can rub off discolourations using a little
cooking oil.
Clean the motor unit 7 and the power cable 9
with a damp cloth. Dry everything properly
before re-using it.
Clean the bowl 5, the lid 3, the pusher 1, the
cutting blades 4, the disc adapter 0, the slicer
attachment w and the grater attachment q in
warm washing up water. Afterwards, rinse all
parts with clean water so that no detergent
residue remain on the parts.
Dry all parts thoroughly, before re-using the
appliance.
NOTE
You can also clean the bowl 5, the
lid 3, the pusher 1, the cutting
blade 4, the disc adapter 0, the slicer
attachment w and the grater attachment q in
the dishwasher.
Place the parts, if possible, in the upper basket
and ensure that none of the parts can get stuck.
Otherwise they could become misshapen or
suffer from stress cracks.

Storage

Store the cleaned appliance in a clean, dust-free
and dry location.
KM 250 D1

Publicité

Table des Matières
loading

Table des Matières