Before First Use; Assembling The Appliance; Cutting Blades - SilverCrest KM 250 D1 Mode D'emploi

WARNING! RISK OF INJURY!
Do not change accessories unless the drive is stationary and the
►
mixer is unplugged from the power supply! The appliance will run on
for a short time after being switched off!
Never leave the appliance unattended!
►
Before changing accessories or additional parts that are in motion
►
during operation, the appliance must be switched off and disconnected
from mains power.
Before first use
■ Remove all packaging materials from the
appliance.
■ Clean the appliance as described in the section
"Cleaning and care".
■ Ensure that all parts are completely dry before
operating the appliance.

Assembling the appliance

NOTE
The appliance will not start until the bowl 5
►
and the lid 3 are correctly attached.
1) Place the motor unit 7 on a flat surface so that
the sucker feet can attach firmly and the
appliance stands firmly in place.
2) Place the bowl 5 onto the motor unit 7 so
that the arrow
towards the open lock symbol
motor unit 7. Then turn the bowl 5 until the
arrow points to the closed lock symbol
and the bowl 5 clicks into place.
If you want to work with the cutting blades 4,
assemble the appliance as described in the section

"Cutting blades".

If you want to work with the food processing
attachments, assemble the appliance as described
in the section "Food processing attachments".
KM 250 D1
on the bowl 5 points
on the
Cutting blades
1) Place the cutting blades 4 onto the drive
shaft 6. The flattened side of the drive shaft 6
must correctly fit into the take up of the cutting
blades 4. Otherwise the cutting blades 4
cannot be properly attached.
2) Place the lid 3 onto the bowl 5 so that the
arrow ▼ on the lid 3 coincides with the
arrow and the opened lock symbol
the bowl 5.
3) Turn the lid 3 until the arrow ▼ on the lid 3
points to the arrow
on the bowl 5.
symbol
4) Place the pusher 1 into the feed tube 2.
5) Insert the plug into a mains power socket.
on
and the closed lock
GB │ IE │
5 ■