Before First Use; Assembling The Appliance; Cutting Blades - SilverCrest KM 250 A1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING! RISK OF INJURY!
To avoid personal injury and damage to the appliance, never insert or
place your hands or any foreign objects into the feed tube.
Do not change accessories unless the drive is stationary and the mixer is
unplugged from the power supply! The appliance will run on for a short
time after being switched off!
Never leave the appliance unattended!
Before changing accessories or additional parts that are in motion during
operation, the appliance must be switched off and disconnected from
mains power.
Before first use
Remove all packaging materials from the appli-
ance.
Clean the appliance as described in the section
"Cleaning and care".
Ensure that all parts are completely dry before
operating the appliance.

Assembling the appliance

NOTE
The appliance will not start until the bowl
and the lid
are correctly attached.
1) Place the motor unit
that the sucker feet can attach firmly and the
appliance stands firmly in place.
2) Place the bowl
onto the motor unit
so that the arrow
towards the open lock symbol
motor unit
. Then turn the bowl
arrow
points to the closed lock symbol
and the bowl
clicks into place.
If you want to work with the cutting blades
assemble the appliance as described in the section

"Cutting blades".

If you want to work with the food processing at-
tachments, assemble the appliance as described
in the section "Food processing attachments".
KM 250 A1
on a flat surface so
on the bowl
points
on the
until the
,
Cutting blades
1) Place the cutting blades
shaft
. The flattened side of the drive shaft
must correctly fit into the take up of the cutting
blades
. Otherwise the cutting blades
cannot be properly attached.
2) Place the lid
onto the bowl
arrow
on the lid
arrow
and the opened lock symbol
on the bowl
.
3) Turn the lid
until the arrow
points to the arrow
symbol
on the bowl
4) Place the pusher
5) Insert the plug into a mains power socket.
onto the drive
so that the
coincides with the
on the lid
and the closed lock
.
into the feed tube
.
GB
25

Publicité

Table des Matières
loading

Table des Matières