Battery Installation And Battery Type Setting (Wet Or Gel/ Agm) - Clarke CA60 20B Mode D'emploi

INSTRUCTIONS FOR USE

BATTERY INSTALLATION AND BATTERY TYPE SETTING (WET OR GEL/ AGM)

According to the type of batteries (WET or GEL/AGM),
set the machine as follows:
NOTE
Regarding the factory setting, learn the battery
type from boot time display according to above
table
1. Press both the buttons (A, Figure. 4) and (B) at the same
time, Insert the ignition key (D) and turn on the power,
after 0.5 second, enter battery setting mode. LED display
during setting( C) ,Release the buttons.
2. The mode can be shift from 0 to 5 by pressing button (B),
or shift from 5 to 0 by pressing button (A). After the
battery mode setting is completed, turn off the power (D)
and the new setting of battery mode can be saved
automatically.
3. The battery type setting is completed.
Mode Battery type/Battery
manufacturer
0 WET
1 GEL/AGM
2 DISCOVER
3 OPTIMA
4 EXIDE
5 FULLRIVER
Battery installation
4. Open the recovery tank cover (1) and check that the recovery tank (25) is empty; otherwise empty it with the drain
hose. (22)
5. Close the recovery tank cover (1).
6. Overturn the recovery tank (25) carefully.
7. The machine is supplied with cables suitable to install 2×12 V batteries. Carefully put the batteries into the
compartment, then install them correctly.
8. Route and install the battery cable as shown in (Figure3), then carefully tighten the nut on each battery terminal.
9. Place the protection cap on each terminal, then connect the battery connector (38).
10. Carefully lower the recovery tank (25).
Battery charging
11. Charge the batteries. (See procedures in maintenance chapter).
Battery charging curve
General WET curve
General GEL/AGM
curve
DISCOVER
OPTIMA
EXIDE
FULLRIVER
9
LED1 LED2 LED3
A B C
Figure 4
LED display during
setting( )
C, Figure. 4
ENGLISH
D
Boot time
display
LED1 blink
twice
LED2 blink
twice
LED3 blink
twice
Both LED1 and
LED2 blink
twice
Both LED1 and
LED3 blink
twice
Both LED2 and
LED3 blink
twice