Operating Guide; Battery Check/Setting On A New Machine - Clarke CA60 20B Mode D'emploi

INSTRUCTIONS FOR USE

OPERATING GUIDE

WARNING!
On some points of the machine there are some adhesive plates indicating:
— DANGER!
— WARNING!
— CAUTION!
— CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates. Do
not cover these plates for any reason and immediately replace them if damaged.

BATTERY CHECK/SETTING ON A NEW MACHINE

WARNING!
The electric components of the machine can be seriously damaged if the batteries are either
improperly installed or connected. The batteries must be installed by qualified personnel only. Set
the function electronic board and the built-in battery charger according to the type of batteries
used (WET or GEL/AGM batteries).Check the batteries for damage before installation.
Disconnect the battery connector (38) and the battery charger plug (8). Handle the batteries with
great care. Install the battery terminal protection caps supplied with the machine.
NOTE
The machine requires two 12 V batteries,
connected according to the diagram (Figure. 3).
The machine can be supplied in one of the following modes:
A) Batteries (WET or GEL/ AGM) already installed and charged
1. Check that the batteries are connected to the machine with the connector (38).
2. Insert the ignition key (54) and turn it to "I". If the green warning light (53) turns on, the batteries are fully
charged. If the yellow (52) or red warning light (51) turns on, the batteries must be charged (see the procedure in
Maintenance chapter).
B) Without batteries
1. Buy appropriate batteries (see the Technical Data paragraph).
2. For battery choice and installation, apply to qualified battery Retailers.
3. Set the machine and the battery charger according to the type of batteries (WET or GEL/ AGM), as shown in the
next paragraph.
-
+
8
ENGLISH
+
12V
12V
-
Figure 3