DS Produkte Z 09271 Mode D'emploi page 25

Cleaning the dust bin, dust fi lter and plastic dust fi lter
1. Remove the suction hose from the dust bin (see chapter "Assembly", section "Inser-
ting/removing the hose").
(E)
the dust fi lter back with the foam fi lter on the plastic dust fi lter and then put the dust
container lid back on the dust container. Screw the dust container lid fi rmly onto the
2. Push the release button on the dust bin and pull it out of
the device by the handle.
3. The dust fi lter is located in the dust container lid, that me-
ans on the plastic dust fi lter. Turn the dust bin cover to
remove it. NOTE: Orientation marks for the removal and
placement of the cover are provided on the cover and dust
bin. You can remove the cover when the mark on the dust
bin is pointing towards the open lock symbol on the cover.
4. Remove the dust fi lter for cleaning. Tap out the contents
of the dust fi lter over a dustbin and brush off the loose
dirt. If necessary, wipe the dust fi lter using a damp cloth.
Never clean the dust fi lter with water!
5. The back of the dust fi lter (E) consists of a black foam fi l-
(D)
ter (D) which can be removed. Remove it and tap out the
contents of the fi lter over a dustbin and brush off the loose
dirt. As required, you may rinse the foam fi lter (!) (D) using
clear, lukewarm water. CAUTION: Never clean the foam
fi lter in a washing machine or dishwasher! Then press
out the fi lter and allow it to dry completely in the air before
reinserting it in the dust fi lter.
6. Remove the plastic dust fi lter from the dust container.
7. If necessary, thoroughly rinse the dust container and the
plastic dust fi lter with clear, lukewarm water. CAUTION:
Do not under any circumstances clean the dust con-
tainer or the plastic dust fi lter in a washing machine
or dishwasher! Then shake off any excess water and al-
low the fi lter to dry completely in the air before reinserting
it.
8. Place the plastic dust fi lter back into the dust container, place
25 EN