Toro 824 XL Power Throw 38084 Manuel De L'utilisateur page 36

2. Remove spark plug from cylinder head. Next,
pour two teaspoons of engine oil into spark plug
hole in cylinder head. Install spark plug in
cylinder head, but do not install wire on the
plug. Then pull recoil starter slowly to distribute
oil on inside of cylinder.
3. Lubricate the snowthrower: refer to Lubricating
Snowthrower, page 19. Change crankcase oil:
see Changing Crankcase Oil, page 20.
4. Clean the snowthrower. Touch up chipped
surfaces with paint. Toro Re–Kote paint is
available from an Authorized TORO Service
Dealer. Sand affected areas before painting, and
use a rust preventative to prevent metal parts
from rusting.
5. Tighten all screws and nuts. If any part is
damaged, repair or replace it.
6. Store snowthrower in a clean, dry place, and
cover it for protection.
GB–24