Connection To A Three-Rail Track - Roco Z21 dual BOOSTER Manuel D'utilisation

Z21 Booster
®_

Connection to a three-rail track

Booster Section 1
Disconnect all three rails!
INFO: In three rail mode, it is important that the polarity is correct as this could otherwise result
in functional disorders in older Motorola
rating points.
CAUTION: Should it be necessary system-related, the outer rail can remain connected and only
the middle rail can be disconnected. This is not recommended however and you do so at your own
risk! It is also to be ensured that only Z21
CAUTION: When using devices that are older and not RailCom
to be taken into account with regard to shared separating points: if a Railcom cutout should be
generated in one section but not in the neighbouring section, micro short-circuiting would take
place when the locomotive crosses the shared separating point. For this reason, the RailCom
the Z21 -Boosters is also to be deactivated when using such set-ups (see Chapter: STOP Button
®
and Configuration).
1082x Z21 , z21
® ®
10805 Z21 light Booster
®
10806 Z21 Single Booster
®
10807 Z21 ® Dual Booster
without Railcom (adjustable)
Disconnection point
10761, 10764 Digital amplifier
10762, 10765 Booster
10779 Braking generator
10786, 10830, 10832 multiZENTRAE
without Railcom (adjustable)
38
38
8010806920 neu.indd 38
MM-Decoder
, z21 start Digital control center
®
Track signal with RailCom
pro
Track signal without RailCom
Booster Section 2
Disconnect all three rails!
decoder. Please use rocker pick-up shoes at the sepa-
®
-Boosters are used with the system!
®
®
RailCom Cutout
®
RailCom RailCom
®
Chanel 1 Chanel 1
®
®
Z21
®
-compatible, the following is
®
25.10.2018 13:04:37
of
®