Rear Panel - Dynacord PowerMate 1000 Mode D'emploi

SPEAKER OUTPUTS RIGHT / LEFT
The PowerMate is equipped with professional SPEAKON
high-performance connectors, offering electrical and
mechanical secure connection, which complies to all security
regulations. It also allows the use of high quality speaker
cables with diameters of 4 x 2.5mm 2 .
The DYNACORD accessory assortment includes all
recommended cables and connectors.
Warning: The symbol "
connectors indicates the presence of touch-sensible voltages,
which can cause harm to body and health.
Please, be sure to adhere to corresponding notes and
instructions in this owner's manual when establishing speaker
connections.
POWER
Mains switch to turn the PowerMate on or off.
The PowerMate is operational when the POWER ON – LED
lights and the power outputs are activated through automatic
switching of the power relays.
Please make sure to set the master faders to their minimum
position or engage the STANDBY switch before switching
the power on. This will save you, your audience, and the
equipment from unnecessary stress.
In case additional external equipment is connected to the
PowerMate – e.g. power amps, FX units, EQs, etc. – please,
proceed in the following order when switching your equipment
on:
1. switch on the FX units
2. switch on the PowerMate
3. switch on external power amps
When switching the power off, please proceed in the opposite
order.
49

REAR PANEL

" representing the speaker