Panasonic EYFPA1J Instructions D'utilisation page 8

7) Do not strain the tool by holding the speed
EN EN
control trigger halfway (speed control
mode) so that the motor stops.
Symbol
V
n
0
... min
-1
Ah
IV
ASSEMBLY
.
NOTE:
• If a worn or deformed socket is used,
the square drive (retainer ring and pin)
may not enter the socket properly.
Attaching Socket (Pin type)
• Remove the socket's rubber ring and pin.
See the illustration
1 Attach the socket to the tool.
2 Insert the pin. (Taking care to align the pin
holes on the socket and tool.)
3 Attach the rubber ring by sliding it into
place over the groove.
See the illustration
Meaning
Volts
Direct current
No load speed
Revolutions or
reciprocations per minutes
Electrical capacity of battery
pack
To reduce the risk of
injury, user must read and
understand instruction
manual.
Do not incinerate or heat
battery pack. Do not charge
or use under conditions of
high temperature. Do not ex-
pose to high temperatures.
Do not disassemble or
modify.
Do not expose to rain or
water.
1
2
NOTE:
• Be sure to attach the rubber ring to pre-
vent the pin from falling out.
Removing Socket (Pin type)
1 Remove the rubber ring.
2 Remove the pin.
3 Remove the socket from the tool.
See the illustration
NOTE:
• Keep the temperature of the tool above
the freezing point (0°C/°F) when
attaching sockets to or removing them
from the square drive on the tool. Do
not use excessive force when attaching
or removing sockets.
Attaching or Removing Bat­
tery Pack
1. To connect the battery pack:
Line up the alignment marks and attach
the battery pack.
• Slide the battery pack until it locks into
position.
See the illustration
. To remove the battery pack:
Push up on the button from the front to re-
lease the battery pack.
See the illustration
Attaching the tool hanger
1. Remove the pin and the clip from the tool
hanger
See the illustration
. Align the holes on the tool hanger with the
holes on the tool body.
See the illustration
. Insert the pin into the holes on the tool
hanger and the tool body.
Attach the clip on the tool hanger's holes.
See the illustration
-  -
3
4
5
6
7
8