Panasonic EYFPA1J Instructions D'utilisation page 16

EN EN
Display
Battery indication lamp
. Press the OK button to accept the select-
ed setting.
• The control panel will stop flashing and
light up.
Checking tool settings
• When the tool stops, the current setting
value will be displayed for approximately 
seconds.
• The setting status cannot be checked while
the tool panel is off. Depress the trigger
switch once to turn on the panel.
Checking the status of the
torque clutch and sung point
detection level setting and
Buzzer settings
1. Press the A button.
• The torque clutch and sung point detec-
tion level setting and buzzer setting val-
ues will be displayed (in that order).
Example: If the torque clutch is set to 0
and sung point detection level setting
L1 and the buzzer is set to sound at the
green indicator, "30" → "L1" → "b1"
Checking the status of the
LED light and rundown error
detecting function and speed
control function settings
1. Press the B button.
• The LED light and tightening time and
speed control setting will be displayed
(in that order).
Example: If the LED light mode is set to
L1 and the tightening time is set to 0
and speed control is set to ON,
"d1" → "20" → P0
Checking the tool circuits and
the status of the cross thread
reduction function and auto
downshift function settings
1. Press the D button.
• The tool circuits and cross thread reduc-
tion function and auto downshift function
settings will be displayed (in that order).
Ex­ample: "H3" → "R1" → "10"
Display
H
NOTE:
• When other tools are in the area which
are not set, they may accidentally
receive a signal when setting the tool
by remote control.
Set the tool in another room if possible
or keep a fair distance to avoid this situ-
ation.
- 16 -
Tool circuit
EYFPA1