Hitachi NR 83AA2 Mode D'emploi page 5

(2) Slide the nail strip forward in the magazine.
The nail strip should pass the nail stopper. (See Fig.
2)
(3) Pull the nail feeder (B) back to engage the nail feeder
(A) to the nail strip. (See Fig. 3)
Nail
Feeder (A)
NOTE:
Use nail strip of more than 5 nails.
The Nailer is now ready to operate.
Removing the nails:
1 Pull the nail feeder (B) backward.
2 Return the nail feeder (B) forward quietly while
pushing the nail feeder (A). (See Fig. 4)
3 Push the nail stopper toward the magazine side, and
pull out nails from the back of the magazine. (See Fig.
5)
Nail Stopper
Fig. 2
Nail Feeder (B)
Fig. 3
Nails
CAUTIONS:
To prevent unintentional operation, never touch the
trigger or place the top end of the push lever on a
work bench on floor. Also, never face the nail outlet
toward any part of a person.
HOW TO USE THE NAILER
CAUTIONS:
Never use the head or body of this device as a
hammer.
Take precautions to ensure the safety of persons in
the vicinity during operation.
1. Nailing procedures
(1) Intermittent nailing
Depress the nail outlet onto the desired point; then
pull the trigger to drive a nail in a single shot.
2
English
1
2
Nail Feeder (A)
2
Nail Feeder (B)
Fig. 4
Nail Stopper
3
Fig. 5
Trigger
3
Push Lever
Fig. 6
4