Replacing The Battery Of The Collar - Num'axes Canifugue FUG 1030 Guide D'utilisation

To activate this push button, use a pointed object such as a pencil tip.
The mode is changed by pressing and holding the push button: a number of beeps (from 1
to 8) is then emitted by the collar.
Keep the button pushed in to run through the modes. Release once the desired mode is
reached: the collar memorises the configuration you select.
This table shows
CANIFUGUE
operates in each mode:
NB: your CANIFUGUE has been set at Mode 4 in the factory. Before using the system,
adjust this setting according to your dog's sensitivity.
The CANIFUGUE pet fencing system comes complete with 3 safety features:
1) Breakage of antenna wire:
If the antenna wire breaks (or the connection fails), the transmitter alerts you to this
operating fault with a beep sound.
2) Leaving the warning zone:
After 20 seconds (approx.) of continuous presence in the warning zone, your dog will be
signalled to leave the zone by the emission of a few short stimulations.
3) Leaving the stimulation zone:
If your dog remains in the stimulation zone for approximately 20 seconds, the system stops
emitting corrective stimulations. The normal functioning resumes when your dog leaves
this zone.

Replacing the battery of the collar


NUM'AXES advises to use the same type and same brand of batteries as those supplied
in your new purchased product. Other brands of batteries may not operate, or may not
Canifugue FUG1030 Guide_Indice I.indd 26
Mode
1
how the 2
3
4
5
6
7
8
Nr
Stimulation level
of beeps
1
Very low (small dog or dog with
2
3
sensitive temperament)
4
Medium (medium dog or
5
6
dog with normal temperament)
7
Very strong (large dog or dog
8
with difficult temperament)
Gb - 26
28/06/2018 14:49