Cleaning, Maintenance And Ordering Spare Parts - EINHELL FREELEXO+ Instructions D'origine

Mowing time settings
•
Operating time
This provides you with information about the
current settings of the operating times of your
robot lawn mower
•
Mowing edges
For a tidy lawn edge, the "Edge mowing" set-
ting can be activated. The robot lawn mower
starts its mowing work every 7 work days by
first mowing once along the entire perimeter
wire. In addition, the robot lawn mower mows
on the way to the charging station at the end
of the daily mowing interval, if the charge le-
vel of the rechargeable battery is over 70%.
•
Fault memory
This provides you with information about the
most recent fault messages of your robot
lawn mower.
•
Mower statistics
This provides you with information about a
range of mower statistics.
Changing the PIN
You can change the PIN for the robot lawn mo-
wer and use your own personal PIN. To do so,
proceed as described in the chapter "Locking
mechanism / PIN". Important! Make a note of the
new PIN.
6.6 Control of the robot lawn mower
Starting procedure
1. Unlock the control panel (2).
2. Press the "START" button (52) fi rst.
3. Close the display cover (24).
The robot lawn mower will now operate in ac-
cordance with the mowing time setting. The batte-
ry charge level is monitored during the work time
and displayed on the LCD-display (50). Whenever
the battery charge level drops to 30%, the robot
lawn mower automatically returns to the charging
station (19).
Stopping mowing
1. To bring the robot lawn mower to an immedia-
te stop, press the STOP button (3).
2. Unlock the control panel (2).
3. Press the "HOME" button (53) to send the ro-
bot lawn mower along the perimeter wire (18)
and back to the charging station (19).
4. Close the display cover (24).
Anl_FREELEXO_plus_SPK9.indb 41 Anl_FREELEXO_plus_SPK9.indb 41
GB
6.7 Control of the robot lawn mower using
the app
All settings that you can make using the control
panel can also be made using the app. To do
so, fi rst download the Einhell app for robot lawn
mowers to your smart phone. The Einhell app is
available via the following link and QR code:
iOS: http://qr.einhell.com/12e103ce
Android: http://qr.einhell.com/176c0443
Use a Bluetooth connection to connect the robot
lawn mower with your smart phone and follow the
steps shown there.
7. Cleaning, maintenance and
ordering spare parts
Hazard!
The equipment must be disconnected from the
power supply (pull out the power plug and switch
off the equipment by the main switch (7) (OFF)
(Fig. 8) prior to performing any cleaning and
maintenance work.
Caution! Wear work gloves!
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
Do not clean the robot lawn mower with run-
ning water, particularly with high-pressure
water.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be ag-
gressive to the plastic parts in the equipment.
- 41 -
14.11.2019 12:52:38 14.11.2019 12:52:38