Complete Conversion - Whirlpool W10477539B Instructions D'installation

To Convert Oven Burner
1. Open the oven door and remove oven racks, oven tray, flame
spreader and set aside.
2. Lift oven burner. The orifice spud is behind the oven burner
air shutter.
A
A. Oven burner
B. Air shutter
3. Locate Natural gas orifice spud stamped "47" in the bag
containing literature supplied with the range.
4. Use a 7 mm combination wrench and remove the LP gas
orifice spud.
5. Install the number "47" Natural gas spud.
A
A. Natural gas oven orifice spud stamped with "47"
IMPORTANT: Do not overtighten.
6. Place LP gas oven burner spud in plastic parts bag along
with LP gas cooktop burner spuds for future use and keep
with the bag containing literature.
7. Reinstall oven burner.
8. Reinstall oven racks, oven tray and flame spreader.
16
1. Refer to the "Make Gas Connection" section for properly
2. Turn the manual shutoff valve in the gas supply line to the
3. Refer to the "Electronic Ignition System" section for proper
B
4. Close the broiler door and press the CANCEL/OFF pad.
5. Refer to the "Complete Installation" section to complete this

Complete Conversion

connecting the range to the gas supply.
open position.
burner ingestion, operation and burner flame adjustments.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
Checking for proper cooktop and oven burner flames is very
important. The small inner cone should have a very distinct
blue flame ¼" to ½" (0.64 cm to 0.13 cm) long. The outer
cone is not as distinct as the inner cone. Natural gas flames
do not have yellow tips.
procedure.