Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Remove the cap from the gas pressure regulator using a
flat-blade screwdriver.
NOTE: Make sure sealing washer remains in the same
position.
A. Cap
3. To convert to Natural gas, unscrew the plastic adjustment
screw by hand, turn it over, and screw it in again.
Inlet pressure
to LP gas
180º
A. Cap
B. Sealing washer
C. Adjustment screw
4. Reinstall the cap.
To Convert Surface Burners
1. Remove burner grate, burner caps and burners.
C
A
A. Burner cap
B. Burner
C. Center burner
A
Inlet pressure
to Natural gas
A
B
C
B
2. Locate the Natural gas orifice spuds for top burners in the
bag containing literature included with the range. Three
Natural gas spuds are stamped "125," one is stamped "132"
and one "128."
3. Remove the LP gas orifice spuds using a 7 mm combination
wrench.
4. Install the Natural gas orifice spuds using a 7 mm
combination wrench.
A. Spud
B. Holder
NOTE: Depending on model, the range cooktop may be
equipped with 4 standard burners, 3 standard burners and
1 power burner, or 3 standard burners, 1 power burner and
1 center burner. Spud size/location remain the same.
A
B
A. Standard burner - Natural gas orifice spud number 125
B. Power burner - Natural gas orifice spud number 132
C. Center burner - Natural gas orifice spud number 128
D. Standard burner - Natural gas orifice spud number 125
E. Standard burner - Natural gas orifice spud number 125
5. Place LP gas orifice spuds in the parts bag for future use and
keep with the bag containing literature.
6. Reinstall burners, burner caps and burner grates.
A
B
C
D
E
15
Publicité
Table des Matières
