Table des Matières
Publicité
10
11
12
09
08
07
06
05
04
03
02
01
FIG. 5 5
LONG G ITUDINAL SECTION
COUPE LONGITUDINALE
SCHN N ITTZEICHNUNG
SECC C ION LONGITUDINAL
SEZIONE LONGITUDINALE
17
16
13
14
15
E
E
E-E
35
1. GENERAL CHARACTERISTICS
TOOL TYPE:
Application range:
suitable for installing electrical compression connectors
kN (sh ton):
Crimping force
Rated operating pressure bar (psi):
Dimensions LxWxH
mm (inches):
kg (lbs):
Weight with battery
Volt DC:
Motor
Battery
Volt / Ah:
Battery charger supply
Volt / Hz:
External supply:
12 - 14.4 V DC
Fully insulated head:
Recommended oil:
AGIP ARNICA 32 or SHELL TELLUS TX 32 or equivalent
Recommended oil for "KV" versions:
AGIP ITE 360 or ESSO TRANSFORMER P60 or equivalent
the tool has a twin speed operation and automatically
Operating speed:
the tool is equipped with a maximum pressure valve.
Safety:
Operating temperature:
2. INSTRUCTIONS FOR USE
(Ref. to Figs. 1 and 2)
2.1) Preparation
The tool can be easily carried using either the handle or the shoulder strap (11) attached
to the rings (15 and 18).
With the tool in the rest position proceed as follows:
– Select the appropriate die set for the connector.
– Insert the die (91) into the upper seat of the tool head (05) until it is locked by die/head
retaining pin (06). To ease the die insertion, keep die/head release pin (10) depressed.
– Press the operating button (17) to advance the ram (14) 3÷4 mm and insert the die (90 )
into the seat on the head of ram (14) until it is locked by die/ram retaining pin (02). To
ease this operation, keep die/ram release pin (04) depressed.
– Insert the conductor in the connector.
– Position the connector between the dies and ensure the correct location of the crimp
points.
N
EVER PRESSURISE THE TOOL WITHOUT INSERTING THE DIES
CAUSE DAMAGE TO THE HEAD AND THE PISTON
4
ENGLISH
B131-C
B131-C-KV
B131-CA
for conductors up to 400 mm
2
(800 MCM)
130 (14.6)
700 (10,000)
420 x 100 x 250 (16.5 x 3.9 x 9.8)
7,1 (15.6)
7,4 (16.3)
14.4
14.4 / 3.0 Li-Ion
14.4 / 3.0 Ni-MH
220 - 240 / 50 - 60
120 / 50 - 60
12 - 14.4 V DC
√
switches from a rapid advancing speed of the
ram to a slower more powerful crimping speed.
-15°C to +40°C (+5°F to +104°F)
,
AS THIS COULD
.
Publicité
Table des Matières
