Table des Matières
Publicité
ENGLISH
2.2) Die advancement
(Ref. to Figs. 1 and 5)
Press the operating button (17) located on
the top of the pressure release button (16)
to activate the motor-pump and advance the
lower die. To halt the advancement, release
the operating button (17) and the motor will
cut out.
Make sure the dies are exactly positioned on the desired crimp points otherwise
re-open dies following instructions as per § 2.4 and reposition the connector.
2.3) Compression
– By keeping the operating button (17) pressed, the motor runs and the ram advances
until the two dies touch.
– It is recommended to continue pumping until the motor stops automatically.
2.4) Release of dies
By pressing the pressure release button (16), the ram (14) will retract and open the dies.
2.5) Head rotation
For ease of operation, the tool head can rotate through 180°, allowing the operator to work
in the most comfortable position.
Warning: Do not attempt to turn the head when the hydraulic circuit is pressu-
rised.
2.6) Die replacement
(Ref. to Fig. 2)
To replace dies proceed as follows:
– Upper die (91)
Take the die off its guide by pushing the die/head release pin (10).
Insert replacement die until secured by the die retaining pin (06).
– Lower die (90)
Take the die off its guide by pushing the die/ram release pin (04).
To facilitate this operation an advancement of the ram (14) by 3÷4 mm is suggested.
Insert replacement die into its guide until secured by the die/ram retaining pin (02).
17
16
5
FIG. 4
EXTERNAL SUPPLY
(only for B131-C and B131-CA)
ALIMENTATION EXTERIEURE
EXT. ENERGIEVERSORGUNG
ALIMENTACION EXTERNA
ALIMENTAZIONE ESTERNA
34
(seulement pour B131-C et B131-CA)
(Nur für B131-C und B131-CA)
(solamente para B131-C y B131-CA)
(solo per B131-C e B131-CA)
Publicité
Table des Matières
