Pre Operation Checks; Supplied Accessories; Check Engine Oil Level - Imer Group MECA 25 D Manuel D'utilisation

3. PRE OPERATION CHECKS

■ Make sure you have read all the warnings to prevent any risk of fire.
■ Make sure there is no flammable or hazardous material next to the pump.
■ Keep away from any naked flame. Do not smoke.
■ Install the pump at least 1 meter away from any building.
■ Never block the air flow of the pump with paper or any other material.
■ Only use the pump outdoors.

3.1. SUPPLIED ACCESSORIES

The following accessories are supplied with your pump:
•
2 hose connectors [(a) Fig. 01];
•
3 hose clamps; [(b) Fig. 01];
•
1 strainer; [(c) Fig. 01];
•
1 instruction manual [(d) Fig. 01].

3.2. CHECK ENGINE OIL LEVEL

■ Never remove the dipstick of the oil sump when the engine is running.
■ Never fill the oil sump up when the engine is running or hot.
■ Never smoke when filling the oil sump up or if, in the vicinity, there are naked flames or if any
other conditions are met to start a fire.
Make sure the pump is on a stable and flat surface.
1. Unscrew and remove the oil filling dipstick plug [(b) Fig. 02];
2. To check the oil level, clean the dipstick plug gauge, using a clean cloth and fit the oil plug back.
Do not screw it to check the oil level;
3. If the oil level is less than the bottom level [(d) Fig. 03], fill the oil sump with correct oil [Fig. 05]
up to the top mark [(c) Fig. 03].
NOTE
Replace the oil as soon as it is contaminated (see the MAINTENANCE INSTRUCTIONS).
Oil capacity (Top level)
MECA 25 D
0.8 L
F
EN
E
R
29