P Reparation; Putting The Transmitter Into Operation - df models DRIVE&FLY Brushless Speedfighter-X 4WD RC Buggy 1/8 Notice D'utilisation

4. P
reParatIoN

.1. Putting the transmitter into operation

Control elements und functions of the transmitter
Follow the separate Operating Instructions for the remote-control transmitter and familiarise yourself with the
control elements and functions.
Pistol grip transmitter with a steering wheel for steering and pull lever for speed
1� Antenna
2� Steering wheel for steering function
3� Joystick for driving function
4� Battery / rechargeable battery compartment (lower side)
5� Control unit
6� PC Link (DSC Port, rear side)
7� Charging socket (rear side)
Control unit (5)
a� Reverse switch steering
b� Control LED
c� Trim steering function
d� Function switch
e� Reverse switch driving function
f� Undervoltage indicator
g� Bind button
h� Trim driving function
i� Dual rate controls
Steering wheel for steering function (2)
Depending on the direction in which the wheel is rotated (channel 1) the servo arm of the connected servo steering moves to
the right or left. And the wheels are driven in to the right or left by the corresponding linkages.
Joystick for driving function (3)
The signal of the control lever (channel 2) controls the speed controller / the accelerator servo /brake servo and is moved to
the front for braking and to the back for accelerating.
PC Link (6)
Using the PC link and the enclosed connection cable, the remote control transmitter can also be used for training on a PC.
Control signals are transmitted from your transmitter to the PC directly via the connection cable. This way valuable experience
can be gained while going easy on your equipment.
Charging socket (7)
The function switch should be in the "OFF" position before you start charging!
Never try to charge dry batteries.
Reverse switch Steering function / Driving function (a, e)
The reverse switch of a channel reverses the direction of rotation of the connected servos or the direction of travel.
Trim controls for channels 1 and 2 (c, h)
The trim fine tunes the zero position of the servo steering and/or the speed control / accelerator servo / brake servo. For this,
the dual rate values should be set to 100%. The fine-tuning is simplified for maximum control travel.
Control LED (b)
The control LED indicates the switched-on state of the transmitter.
Function switch (d)
The transmitter can be switched on or off using the function switch.
Undervoltage indicator (f)
The LED indicates the state of charge of the transmitter batteries. The battery voltage is sufficient (> 9V) as long as the LED
is green.
Bind button (g)
To restore/establish the link between transmitter and receiver after changing the receiver and transmitter or to rectify an
error.
1
5
2
4
-  -
6
7
5
a
3
b
g
c h
d
e
f
i