Maintenance And Inspection - Hitachi NT 65M2 Manuel D'instructions

English
NOTE:
The information contained in this Manual is designed to assist you in the safe
maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that differ
from those on your own Nailer.

MAINTENANCE AND INSPECTION

Read section titled "SAFETY" (pages 4 – 7).
● Disconnect air hose and remove all nails from Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Clearing a jam
Remove a jammed nail in the following
order:
1 DISCONNECT AIR HOSE.
2 Remove all nails.
3 Release the lock lever and open guide
plate (A).
4 Remove the jammed nail with a slotted-
head screwdriver.
5 Close guide plate (A) and latch.
6 In case of frequent jam, contact a
Hitachi authorized service center.
2. Inspecting the magazine.
1 DISCONNECT AIR HOSE.
2 Clean the magazine. Remove dust
which may have accumulated in the
magazine.
3 Lubricate the nail rail with Hitachi
pneumatic tool lubricant.
24
MAINTENANCE
WARNING
3
Lock lever
3
Guide plate (A)
3
Nail rail
1
Disconnect
air hose
4
1
Disconnect
air hose