Oscartielle ANDROMEDA 210 Mode D'emploi page 22

Generally clean the cabinet every three months: unplug and empty completely. Wait for any ice in the evaporator fins in
the top section to melt away and then carefully clean with a soft bristle brush. Again, always wear protective gloves to
avoid cutting your hands. Before plugging the unit in again, always check that all internal parts are completely dry.
We recommend getting the unit serviced once a year by a refrigerator expert or qualified personnel.
13 - Emergencies
Warning: If the unit stops or doesn't start:
- Check there isn't a black-out.
- Check the unit is plugged in properly.
- Check the switch fitted above the plug (if any) is flipped.
If none of the above are responsible for the problem, call your nearest service centre and empty the unit (placing the
products in suitable storage cells to avoid breaking the cold chain).
Warning: If the unit doesn't cool the products enough:
- Check that the condenser is clean and capable of exchanging the heat; otherwise, see point 12.
- Check that the unit has been loaded properly and that the air intake isn't blocked; otherwise, see point 8.
- Check that the unit isn't close to strong air flows or heat sources (see point 4).
- Check that the unit is leveled and that the environmental conditions meet those indicated in point 4.
If the problem persists despite the above checks, contact your nearest service centre.
Warning: Never approach the motor compartment in the event of leaking gas or a fire. Unplug at the mains. Never use
water to put out any flames, but only dry powder extinguishers. All the materials used to build the unit are fire-proof or
self-extinguishing and non-flammable.
14 - Customer service
In case service is required and/or mechanical, electrical or compressor components need to be replaced, please contact
the dealer from whom you purchsed the unit and ask for original spare parts.
15 - Dismantling and elimination of cabinet
For environmental reasons and in compliance with the regulations in your country, separate the parts of the cabinet for
disposal and/or recycling.
All the parts that make up the cabinet are made of materials that are not classifiable as urban waste except for the
metallic parts that are not classified as special waste in most countries. As regards the parts of the refrigeration circuit,
that is the refrigerating gas and lubricating oil, these should not be disposed of carelessly and can be recycled by
specialized centers.
This product contains HFC, namely fluoridated gasses, a refrigerating gas with a high Global Warming Potential
(GWP) regulated by the Kyoto protocol.
The gas contained in foam polystyrene for thermal insulation of the cabinet is (R134A).
Oscartielle equips its plug-in cabinets with the following types of refrigerating gasses:
R 134a; GWP = 1300
(100)
R 404A; GWP = 3750
(100)
This unit is hermetically sealed and the refrigerating gas load is under 3 kg.
For this reason it is not subject to the requisite of an installation booklet and periodic inspections for leakage of
the refrigerating gas (presidential Decree no. 147 of February 15th 2006, Art. 3 and 4).
16 - Manufacturer's statement (Start-up prohibition)
The above models are also built to be assembled in-line with other items of machinery to produce a machine, as defined
by Directive 2006/42/CE.
Therefore, the Manufacturer hereby states that it not permitted to start the unit up until the machine in which it is
incorporated (or it will become a part of) has been identified and its compliance with the provisions of Directive
2006/42/CE and applicable national laws has been stated. In other words, until the machine referred to in this statement
becomes one with the final machine.
17 - Information for Technical Services – Cabinets with R290 refrigerant gas (Propane)
Any service on cabinets charged with R290 refrigerant gas must be performed only by well skilled and trained
personnel on R290 gas handling procedures. The activities must be performed by personnel indicated by the
Manufacturer or by the Dealer who sold the cabinet.
The service and any kind of intervention on the refrigeration system of cabinets charged with refrigerant gas R290
requires additional precautions!
1. It is not possible to carry out refrigerant filling, draining, emptying, or recharging operations because the entire
refrigeration circuit is hermetically sealed.
2. Before starting any work, turn off the cabinet and disconnect its electrical plug from the power supply socket.
3. The working tools must be suitable for repairing cabinets charged with R290 gas.
4. The intervention on the refrigeration circuit must be performed in well ventilated areas or outdoors only.
20