Fault Codes - Inventum VVW6008AW Manuel D'utilisation

Problem
The dishes are not dry.
There are rust stains on the dishes.

FAULT CODES

If the appliance has a fault the start/pause button or one or more of the program-step indicators blink.
Fault Start/pause
button
Overflow/Leakage -
Drain time out Blink
Presence flow -
meter impulses
Absence flow meter -
impulses
Empty level Blink
Re-fill time out Blink
NTC ca/cc Blink
Overheating Blink
Unsuccessful -
heating
Parameter set salt Blink
incorrect
CK parameters Blink
High voltage Blink
Low voltage -
52 • English
Possible cause
The cap of the salt reservoir is not
closed correctly.
The selected program does not
include drying.
The level of rinse aid consumption is
set too low.
The stainless steel quality of the
dishes is insufficient.
There is a high level of salt in the
water.
The cap of the salt reservoir is not
closed correctly.
Any spilled salt during filling of the
salt reservoir was not cleaned
immediately.
There is a problem with the
grounding of the mains supply.
Wash Dry End
Blink - Blink
- - Blink
- - Blink
Blink - -
- - -
- - -
Blink - -
- Blink -
Blink Blink -
Blink - Blink
Blink Blink Blink
Blink Blink -
Blink Blink Blink
Possible solution
Make sure that the cap of the salt
reservoir is closed firmly.
Choose a program that includes
drying. Refer to section
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption' .
Make sure that you only clean
dishwasher-safe dishes in the
appliance.
Adjust the level of salt consumption.
'Setting the level of
Refer to section
salt consumption'
.
Make sure that the cap of the salt
reservoir is closed firmly.
Make sure that you clean any spilled
salt immediately and run a full
program to prevent corrosion.
Contact an authorized electrician.
Notes
During normal operation only leakage is
shown.
During normal operation this fault is not
shown.
During normal operation this fault is only
shown at the end of a program.
During normal operation this fault is not
shown.
'Programs'
.