Fault Codes - Inventum IVW6008A Manuel D'utilisation

Problem
The dishes are not dry.
There are rust stains on the dishes.

FAULT CODES

The fault codes are shown on the display of the control panel.
Fault code Possible cause
F5 There is insufficient water supply.
F3 The water supply does not stop.
48 • English
Possible cause
The level of rinse aid consumption is
set too low.
There is a high level of water
hardness and no salt is used.
The level of water hardness is set
too low, which affects the salt
consumption.
The cap of the salt reservoir is not
closed correctly.
The selected program does not
include drying.
The level of rinse aid consumption is
set too low.
The appliance is unloaded too
quickly after the program is finished.
The stainless steel quality of the
dishes is insufficient.
The level of salt consumption is set
too high.
The cap of the salt reservoir is not
closed correctly.
Any spilled salt during filling of the
salt reservoir was not cleaned
immediately.
The water supply is polluted.
Possible solution
• Make sure that the water tap is fully open and that
the water supply is not blocked.
• Close the water tap, remove the water inlet hose and
clean the filter of the hose.
• Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
• Close the water tap.
• Contact the Inventum-servicedienst.
Possible solution
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption' .
Fill the salt reservoir. Refer to
'Filling the salt reservoir'
section
Adjust the level of salt consumption.
Refer to section 'Setting the level of
salt consumption'
.
Make sure that the cap of the salt
reservoir is closed firmly.
Choose a program that includes
'Programs'
drying. Refer to section
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption'
.
Wait a few minutes after the program
is finished before you unload the
appliance.
Make sure that you only clean
dishwasher-safe dishes in the
appliance.
Adjust the level of salt consumption.
'Setting the level of
Refer to section
salt consumption'
.
Make sure that the cap of the salt
reservoir is closed firmly.
Make sure that you clean any spilled
salt immediately and run a full
program to prevent corrosion.
Do a check on the water supply.
.
.