The robot vacuum cleaner will travel to
the base station and recharge. The
base station contact indicator will go
out.
Finishing vacuuming manually
Press the Power button on the re-
mote control.
The robot vacuum cleaner will switch
into standby automatically after approx.
60 seconds. The display will be deacti-
vated. The battery capacity status indi-
cator will continue to light up.
You can switch the robot vacuum
cleaner into standby before 60 sec-
onds is up by pressing the Power but-
ton again.
The robot vacuum cleaner is reactivated
by pressing any button on the remote
control or one of the two sensors in the
robot vacuum cleaner display.
Vacuuming modes
There are four different vacuuming
modes.
Auto
Standard vacuuming mode
for normally soiled flooring.
Spot
Targeted vacuuming of an
area approx. 6 x 6 ft (1.8 x
1.8 m) around the selected
starting point of the robot
vacuum cleaner.
Corner
For vacuuming normally
soiled flooring (see Auto).
Additional edge vacuuming
after returning the starting
point.
Short
For vacuuming lightly soiled
flooring with a short vacu-
uming duration.
Selecting the vacuuming mode
Press the Power button on the re-
mote control.
There are two ways of selecting the
vacuuming mode.
Option 1 (Remote control)
Press the button for the vacuuming
desired mode. The corresponding
vacuuming mode symbol will light up
in the display.
en
17