Hitachi DV 14DL Instructions De Sécurité Et Mode D'emploi page 15

Battery
Charge status
lamp (red)
Overheat lamp
(green)
Fig. 4
2. Insert the battery to the battery charger
Insert the battery into the battery charger as shown in Fig. 4. Make sure it contacts the
bottom of the battery charger.
3. Charging
When the battery is connected to the battery charger, charging will commence and the
pilot lamp will light in red. (See Table 2)
NOTE: If the pilot lamp flickers in red, pull out the plug from the receptacle and check
if the battery is properly mounted.
When the battery is fully charged, the pilot lamp will bilink in red slowly. (At 1-second
intervals) (See Table 2)
Before
Charge
charging
status
lamp (RED)
While
charging
Charging
complete
Charging
impossible
Overheat Overheat
lamp standby
(GREEN)
NOTE: When standby for cooling battery, UC18YRL cools the overheated battery by cooling
fan.
<UC18YRL>
1. Insert the plug of battery charger into the receptacle
When the plug of battery charger has been inserted into
the receptacle, the charge status lamp will blink in red.
(At 1-second intervals)
Table 2 Lamp indications
Indications of the pilot lamp
Blinks Lights for 0.5 seconds. Does not light
(RED) for 0.5 seconds. (off for 0.5 seconds)
Lights Lights continuously
(RED)
Lights for 0.5 seconds. Does not light
Blinks
for 0.5 seconds. (off for 0.5 seconds)
(RED)
Lights for 0.1 seconds. Does not light
Flickers
for 0.1 seconds. (off for 0.1 seconds)
(RED)
Lights
Lights continuously
(GREEN)
WARNING:
Do not use the electrical cord if
damaged. Have
immediately.
Malfunction in the
battery or the charger
Battery
Unable
(Charging will commence
when battery cools).
English
it repaired
overheated.
to charge
15