EIBENSTOCK EST 350.2 Notice Originale page 19

Therefore, always use protective gloves when changing the grinding
wheel.
Before any work on the tool, disconnect the plug from the mains!
Press the shaft lock (Fig.6) so that the wheel cannot revolve and use the
socket wrench to loosen the hex bolt by turning it counterclockwise (Fig.7).
Then remove the hex bolt, Washer, outer flange and wheel.
Note: Do not remove the inner flange and the ring.
Clean the work spindle and all parts to be mounted.
To install the wheel, follow the removal procedures in reverse.
CAUTION:
• Be sure to tighten the hex bolt securely. Insufficient tightening of the
hex bolt may result in severe injury. Use the socket wrench provided
to help assure proper tightening. Always use only the proper inner
and outer flanges which are provided with this tool.
When mounting the diamond cutting discs, ensure that the
•
direction of rotation arrows on the diamond cutting disc match
with the rotation direction of the machine (see direction of
rotation arrow on the protective hood).
Use only original accessory!
•
The EST 350.2 is in power and speed optimal adjusted to the
•
EIBENSTOCK-diamond cutting discs.
In order to check whether the spindle stop is released before you
switch on the tool, turn the spindle slightly.
Let the machine run for a short period of time and in a safe position. If
the machine does not run easily, stop working immediately.
Dust Extraction
Dust which occurs during your work is hazardous to health. That is
why the EST 350.2 must be used with a vacuum cleaner, and a dust
mask has to be worn.
The suitable Wet/Dry Vacuum Cleaner (dust category M) is available as
accessory. It can directly be attached to the connection on the dust hood
(Fig.8).
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist. Due to its design, the machine needs a minimum of care and
maintenance. However, the following points always have to be observed:
Always keep the power tool and the ventilation slots clean.
19