EIBENSTOCK EST 350.2 Notice Originale page 18

To grip workpieces, push the vise handle until the vise plate contacts the
workpiece. Flip the lever forward and then turn the vise handle clockwise to
securely retain the workpiece (Fig.5).
CAUTION:
Always set the lever forward when securing the workpiece. Failure to
do so may result in insufficient securing of the workpiece. This could
cause the workpiece to be ejected or cause a dangerous breakage of
the wheel.
Operation
Hold the handle firmly.
Keep hands away from the cutting area while the machine is running.
Attention!
Before each cut, clean the opening in the machine table in which the
cutting disc dips. Remaining pieces can cause damage to the cutting
disc.
Switch on the tool and wait until the wheel attains full speed before lowering
gently into the cut. When the wheel contacts the workpiece, gradually bear
down on the handle to perform the cut. When the cut is completed, switch off
the tool and WAIT UNTIL THE WHEEL HAS COME TO A COMPLETE
STOP before returning the handle to the fully elevated position.
CAUTION:
Proper handle pressure during cutting and maximum cutting efficiency
can be determined by the amount of sparks that is produced while
cutting. Your pressure on the handle should be adjusted to produce
the maximum amount of sparks. Do not force the cut by applying
excessive pressure on the handle. Reduced cutting efficiency,
premature wheel wear, as well as, possible damage to the tool, cut-off
wheel or workpiece may result.
Noticeable decreasing work progress and circular sparking are indications of
a blunt diamond cutting disc. Briefly cutting into abrasive material (e. g. lime-
sand brick or the EIBENSTOCK-diamond-sharpening-stone) can re-sharpen
the disc again.
Changing the Diamond Cutting Discs
Attention!
The Cutting discs, spacer discs and the flange nut might heat up
enormously during operation. You could burn your hands or get cut or
ripped by the segments.
18