DeWalt DCE350 Guide D'utilisation page 11

the light will dim to 25% indicating that the light is going
to turn off.
LED Display (Fig. D)
The LED display on the top of the crimping tool includes
the power ON/OFF button
12
complete LED 16 , battery state of charge LED
temperature LEDs 18 . Refer to the LED Indications chart
for specific information.
FIG. D
18
When the battery state of charge LED
color, the tool is ON.
D WALT CRIMP CONNECT™ System
e
This crimping tool is capable of connecting with a computer
via the micro USB port 13 on the back of the tool using the
micro USB cable included with your tool. This allows the
user to connect the D WALT crimping tool to a computer
e
which utilizes D WALT's CRIMP CONNECT
e
software.
nOTE: The CRIMP CONNECT™ System software is governed
by separate terms and conditions available for viewing
through the software download.
step 1: Download the CRIMP CONNECT™ System software
to your computer at www.dewalt.com/crimpconnect.
step 2: Follow the instructions in the software to create
your CRIMP CONNECT™ System account.
step 3: Connect your crimping tool with the D
CRIMP CONNECT™ System software by first connecting the
provided micro USB cable to the micro USB port
back of the tool to a USB port on a computer. Then go to
the Home screen of the program to access tool tracking and
usage reports stored on the crimping tool.
nOTE: The USB connection will not charge the tool's battery
pack.
For more information on D WALT CRIMP CONNECT™ System
e
functionality and features, please call 1–800–4-D
(1–800–433–9258), visit www.D
page and help screens located inside the software.
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

WARNING: Inspect the indenters and connectors
before use. Only use properly matched
connectors and cable.
maintenance LED , cycle
15
17 , and
12
15
16
17
17 is lit, regardless of
System
TM
WALT
e
13 on the
WALT
e
WALT.com or view the FAQ
e
Installing and Removing the Battery Pack
(Fig. E)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack into the tool handle, align the
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
FIG. E
Proper Hand Position (Fig. F)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the main handle
7 as shown.
FIG. F

WARNING: CUT OR AMPUTATION HAZARD. Never
have any part of your body near the crimp head or
moving parts during the crimp cycle, or whenever the
main power is ON. Serious personal injury may occur.

WARNING: Proper material preparation and
installation is the responsibility of the installing
contractor.

WARNING: The crimp connectors must be used
in compliance with applicable building codes
and as approved by the authorities having
jurisdiction. For proper installation procedures and
to reduce the risk the risk of failure resulting in injury
or property damage, follow all published safety and
installation instructions.
English
7
9