Milwaukee 2452-20 Manuel De L'utilisateur page 4

FUNCTIONAL DESCRIPTION
1
2
3
1. Hex drive chuck
(2453-20)
2. LED
3. Control switch
4. Trigger
5. Handle
6. Belt clip
7. 2-Mode drive control
8. 1/4" Square drive shank
(2452-20)
9. 3/8" Square drive shank
(2454-20)
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Use only sockets and other accessories specifi-
cally designed for use on impact wrenches and
drivers. Other sockets and accessories might
shatter or break causing injury.
Attaching and Removing Accessories
Square drive shank
(Cat. No. 2452-20, 2454-20)
These impact wrenchs are intended only for use with
sockets designed for impact wrenches that have a
1/4" (Cat. No. 2452-20) or 3/8" (Cat. No. 2454-20)
square drive. Other sockets could shatter or break,
causing injury.
1. To attach a socket or other accessory, align the
accessory with the drive shank and push it firmly
over the retaining ring.
2. To remove the accessory, pull the accessory off
the drive shank.
7
4
8
9
This driver is intended for use with drill and driver
bits with a 1/4" hex shank and ball detent recess.
1. To attach an accessory, press the shank into the
hex drive chuck.
2. To remove the accessory, pull out the ring and
remove the accessory. Release the ring.
6
5
WARNING
to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Always remove battery pack before changing
or removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
To determine the amount of charge left in the battery,
turn the tool ON. The Fuel Gauge will light up for 2-3
seconds. When less than 10% of charge is left, 1 light
on the fuel gauge will flash 4 times.
To signal the end of charge, 1 light on the fuel gauge
will flash 8 times and the tool will not run. Charge
the battery pack.
If the battery becomes too hot, the fuel gauge lights
will flash in an alternating pattern and the tool will not
run. Allow the battery to cool down.
Using the Drive Control
The drive control button is used to
adjust the torque, rotation speed
(RPM), and impact speed (IPM)
for the application (see Specifica-
tions chart for RPM and IPM).
To select the drive control mode:
1. Pull and release the trigger to
turn on the tool. The current
mode indicator is lit.
2. Press the drive control but-
ton to cycle through the
2 modes. When the desired
mode indiator is lit, begin work.
4
Hex drive chuck
(Cat. No. 2453-20)
OPERATION
To reduce the risk of injury, always
wear proper eye protection marked
Fuel Gauge
Mode
Indicator
Drive Control
n
Butto