Electrolux IK 325 Mode D'emploi page 42

open for longer than 2 minutes then the
lamp starts to flash. Make sure after clo-
sing that the doors are fully sealed. The
self-closing hinges assist this.
The cooling time for beverages and other
■
products can take up to 6 hours from
room temperature down to the cold
room temperature. The warmer they are
when put in, the longer this time will be.
Re-setting the temperature control has
■
no effect on the cooling rate, only on
the temperature reached.
Allow warm or really hot products cool
■
down outside the appliance.
Condensation can form on the glass
■
shelves if products are stored which emit
water vapour.
As the electronic control in the cold
■
room only defrosts about once per day,
the ice formation on the rear wall in the
cold room itself can be more marked
than is usual in previous refrigerators.
Be careful that products do not come
■
into contact with the rear wall of the
cold room so that they do not freeze to
it and that, during defrosting, water
does not get diverted into the cold
room.
When filling be careful that:
■
– Oil and fats do not come into contact
with the polymer parts and the door
seals.
– The coldest locations in the cold room
for any setting of the temperature
controller are at the back wall and
above the lowest shelf. Sensitive pro-
ducts should therefore be put on the
lowest shelf.
Example of how to use:
■
– Freeze and store foodstuffs and make
ice in the freezer compartment.
42
– On the shelves from top to bottom:
baked products, ready-made meals,
dairy products, meat and sausages.
– In the suspended trays from top to
bottom: butter and cheese, tubes,
small cans and eggs, large bottles.
– In the vegetable compartment: vegeta-
bles, fruit and salad.
Changing the LED lighting
Switch off the power supply: pull out
the power supply plug or deactivate
the fuse.
Click off the LED lighting (Figure )).
Disconnect the plug to the LED lighting
(Figure +). Please insert the new LED
lighting in the reverse sequence.
N.B.: Please only use original LED
lighting from the manufacturer.
)
+